Mobile devices managed with the Exchange Server connector or on-premises MDM don't install the Configuration Manager client. This behavior happens if the site discovers a device but the client isn't installed and assigned. After the client assigns to a site, update collection membership, and then refresh the console view.Ī device can also display in the console when the Configuration Manager client isn't installed. The likely cause of this is a failed task sequence, so when possible, review the logs and determine if there’s an issue with your Task Sequence which needs to be addressed.If you install the Configuration Manager client, but it hasn't yet successfully assigned to a site, it might not display in the console. Restart the CCMExec service and run a policy retrieval – hey presto, your client will appear in SCCM and start working as expected. = TrueĬonfigure the ProvisioningMode value to be “False”, and clear out the “SystemTaskExcludes” string. When a client is successfully completed then the provisioning mode is disabled, allowing the SCCM Agent to continue it’s duties.Ĭheck the following registry key to verify if the client is in Provisioning Mode: When a client is being built it, for obvious reasons policies and software deployment are prevented. Provisioning Mode is enabled when the client itself is being built by the task sequence. The likely reason is that the client itself is actually in Provisioning Mode. One of the symptoms is when you access Configuration Manager from the Control Panel of the client only a subset of actions appear under the Actions tab: When working with SCCM clients you may stumble across a client which is missing from SCCM itself yet the agent appears to be running fine on the client.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |